Programming Access Codes And Cards - jablotron OASiS JA-83K Installation Manual

13 Programming access codes and cards

Code name Amount
Service 1
Master 1
User 50
JA-83K control panel installation manual
Sequence
 Only programmable
5 NC NC
 NC =
code (must be entered tw
new

Factory -default service code: 8080
 This code can b
Example: 5 4567 4567
5 MC N  O ly programmable if the sy
C n

MC = master code or c
NC
 NC = new code or card ent
presented once
 Either a code or a card can be prog
 Th
e Maste
 Th
e Master Code's reaction is s
 To reset the Master Code to the factory default 1234, enter 291 in Service Mode (this will only
affect the Mas
 To make han
system card (provided with the control panel) to t

5 1234 and then presenting the c
Example:
  Only programmable if the system is tot
6 MC nn
 MC = Master Code or card.
NC
 nn = user code or card position from
 NC = new code or card entry.
 Factory default: all us
 Each user position can have both a card and a code program
6 MC nn NC twice)
 Each user code can have its own reaction programmed by an installer in Service Mode, an
with a split system, codes can be assigned to different sections.

6 1234 12 4345 (code 4345 will be programmed to user position 12)
Example:
To erase codes/cards enter:
6 MC nn 0000 erases the code and the card in user position nn.
6 MC 00 UC erases the code UC (or card UC) if programmed to any user position.
6 MC 00 0000 erases all user codes and cards in user positions 01 to 50.
fig. 19 Programming access codes and cards (only in the disarmed state)
Service Mode.
in
ice) – a card cannot be used.
e changed but not er ased.
stem is totally unset (disarmed)
ard (factory default 1234)
ry – a numerical code has to be entered twice, but a card only
rammed as a master code (to have both is impossible).
r Code can be chan ge d but not erased.
et/unset and it is assigned to all sections.
ter Code).
ding over the system to the end user easier, we recommend programming the
ally unset
01 to 50.
er codes and cards are
- 20 -
Notes
he master code.
ard to the keypad's RFID reader
erased.
med to it (by using the sequence
d
MKG51101