Table of Contents
Advertisement
o IMPORTANT: You must observe the ventilation requirements
shown in the drawing above.
o IMPORTANT: There are ventilation holes around
the outside of the cooktop. YOU MUST ensure
that these holes are not blocked by the work
top, when you put the cooktop into
(see drawing opposite).
o NOTE: Your appliance comes fitted with a sealing
strip already attached to the underside of the cooktop.
This should not be removed as it will prevent liquid or
spillages from penetrating the underneath of the
cooktop.
o IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the
cooktop from the aperture in future, particularly if it needs to be
serviced.
o Carefully lower it into the aperture hole that you have cut out.
(A)
Bracket
(B)
Screw
(C)
Sealing strip
o Place the clamp (A) over the holes that match the size of the
screws. There are one set of screw holes in each corner of the
position
16
Advertisement
Table of Contents
