Adjusting The Volume - Canon Elura 60 Instruction Manual

Adjusting the Volume

When you use the LCD screen for playback, the camcorder plays back the sound via
built-in speaker. The built-in speaker does not sound when you close the LCD panel.
Use headphones when using the viewfinder.
H (phones) terminal
When Using Headphones
The headphones terminal also serves as AV terminal. Headphones can only be used
when "H" is displayed on the screen. If not, change the setting following the
procedure below.
CAMERA
( 38)
Open the menu and select [VCR SETUP]. Select [AV/PHONES H ], set it to
[PHONES H ] and close the menu.
❍ The built-in speaker does not sound when "H" is displayed.
❍ Do not connect headphones unless "H" is displayed as it produces noise.
Adjusting the Volume
CAMERA
Turn the SET dial up to increase the volume, and down
to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the SET dial
down until [OFF] appears. Turn the SET dial up to increase the volume again.
34
SET dial
PLAY (VCR)
VCR SETUP
PLAY (VCR)
Built-in speaker
CARD CAMERA
AV/PHONES ••AV
CARD CAMERA
CARD PLAY
CARD PLAY