Removing the Brewer Cylinder
1.
Remove the brewer piston
2.
Remove the five screws securing the brewer cylinder assembly to the cylinder base and
set them aside for now.
3.
Turn the drive gear at the bottom of the brewer counter-clockwise while, at the same
time, lifting the base away from the cylinder until it is free, and then remove and
discard the old cylinder assembly.
4.
Remove the piston rod assembly from the piston, and set it aside as you will be re-
installing it later in this procedure.
VKI Publication #202378-001
(see page
27).
Eccellenza Momentum™
29