Keurig Eccellenza Momentum Service Manual page 30

Service Manual
5.
6.
30
Compress the clips on the tip of the valve body and lift the valve activator to remove it
and the other brew valve components.
Assemble the new cylinder (consult VKI Publication #100310-001 for the required parts
and their part numbers).
A) Install the valve housing onto the cylinder (making certain in is pushed down
completely), and then install the two o-rings onto the valve housing.
B) Install the U-cup seal into the valve housing (flat side up).
C) Install the thick o-ring onto the valve head.
D) Pass the valve head through the valve housing from the inside of the cylinder. You
need to hold the valve head in this position to perform the next step.
E) Place the spring into the U-Cup seal (with the valve head in the middle of the spring)
and then install the valve activator over the spring (flatter side towards the front).
While holding the valve body in place inside the cylinder, press firmly on the valve
activator until the tip of the valve body passes through the activator, locking
everything in place.
F) Install the seal into the recession in the bottom center of the cylinder.
VKI Publication #202378-001