Keurig Eccellenza Momentum Service Manual page 64

Service Manual
7.
8.
9.
10. Connect all of the wiring harnesses onto the control board.
64
Align the replacement control board with the six clips on the board mounting posts.
Gently push the control board down onto all of the clips until the board is securely
mounted to them.
Pass the heater wire though the current detector on the control board.
If this is not done, the machine will constantly display an "H1" error as the power
going to the heater will not be detected.
Each harness only fits on its respective connector on the control board.
However, note that there are two 3-pin connectors on the control board. The
3-pin wiring harness must be connected to the 3-pin connector at the top of
the board or the customer's 20-amp circuit breaker may trip.
After replacing the control board, the firmware must be loaded when the
machine is first powered up. Do not power up the machine until the USB
Flash drive with the proper firmware is connected to the machine.
VKI Publication #202378-001