Carrier XCT7 40VH A-7G Series Installation And Owner's Manual page 15

Safety Considerations
• Install full heat exchange unit in places
where the weight of the same can be
properly and adequately borne.
The unit may fall off weak bases to cause
casualty.
• Do not mount control in places where water
splashes. Soaked control internal causes
electric shock or internal electric part fault.
Considerations for Removing, Reinstalling/Maintaining.
• Do no refit the device.
Electric shock or fire accident may ensue.
• Distributors or service network points
shall be asked to remove or reset the unit.
Incomplete installation will cause water
leakage, electric shock and fire accident.
Control connection shall be done in
correct mode.
Otherwise, electric shock or fire
ensues. Do not pull at or wring out
control wire. Such practice causes
failures.
• Make sure that measures are taken to
guard against snowing weather.
Without effective protection, snow
will enter external air hoses to damage
furniture, cause electric shock and fire
accident.
In case that certain gas gets checked
outside the unit, fire accident may
ensue.
• Do not overhaul the device unaided
by concerned specialists.
Electric shock or fire accident may
ensue.
7