Tripp Lite NetCommander B072-016-IP4 Owner's Manual page 7

1. Product Overview
To set the IPv4 address via the local console OSD:
1. From the local console, press the left [Shift] key twice to open
the OSD.
Press the [F2] key to open the Settings menu.
2.
3. In the Settings menu, press the [Tab] key until the DHCP field is
highlighted. Press the [Spacebar] key to toggle the DHCP field
from Enabled to Disabled.
4. Pressing the [Tab] key to navigate to the additional fields, type
in the desired IP Address, Subnet Mask, Gateway, and DNS
Server Address (Optional).
Once the IP address is satisfactory, press the [Esc] key to save
5.
your changes. This will require a reboot of the KVM to save the
new settings.
To set the IPv6 address via the local console OSD:
1. From the local console, press the left [Shift] key twice to open
the OSD.
2. Press the [F2] key to open the Settings menu, and then press
the [F2] key again to open the IPv6 Settings menu.
3. In the IPv6 Settings menu, with the Mode field at the top of the
screen highlighted, press the [Spacebar] key to toggle between
DHCP , Stateless, and Static. DHCP is selected by default, and
automatically assigns an IP address via the IPv6 DHCP server.
Stateless is an option for networks with a compliant router
that performs Stateless IPv6 configuration. Static allows you to
manually assign an IP address.
4. Pressing the [Tab] key to navigate to the additional fields, type
in the desired IP Address, Gateway, and DNS Server Address
(Optional). Note: DNS IP should be set to 0.0.0.0 to indicate
no DNS.
5. Once the IP address is satisfactory, press the [Esc] key twice
to exit and save your changes. This will require a reboot of the
KVM to save the new settings.
7