Viewing Stored Test Results; Printing Separate Air And Bone Conduction Audiograms; Setting Up Printout - otometrics Madsen Midimate 602 Quick Manual

MIDIMATE 602 & 622 Diagnostic Audiometers
The display shows Printing ... during printout. In MIDIMATE 622, versions 3.0
and 3.1, the Ext. Range HL lamp flashes during printout.
8.2.3

Viewing stored test results

To view the stored thresholds, do as follows:
1. If required, reselect the test mode with the same function and output as the
thresholds to be viewed by pressing Menu and then using the Select Func-
tion sequence.
2. Press Softkey 3, View.
3. If required, toggle L/R Shift to select the appropriate ear.
4. Turn the Frequency or Hearing Level knob to change the frequency of the dis-
played threshold.
8.2.4

Printing separate Air and Bone Conduction audiograms

MIDIMATE 622 prints out both Air and Bone Conduction thresholds on the same
audiogram (if there is one). To obtain separate audiograms, do as follows:
1. Test the patient with the first transducer type to be used.
2. Print out the stored thresholds that were registered.
3. Clear the stored data by pressing Softkey 5, Clr-All, in the Printer Menu.
4. Test the patient with the second transducer type.
5. Print out the stored thresholds that were registered with the second transducer
type.
With Softkey 1, Clr-L, and Softkey 2, Clr-R, stored left and right thresholds can be
retained or cleared independently of each other.
8.3

Setting up printout

To set up printout on the MIDIMATE 622, do as follows:
1. Switch off the MIDIMATE 622.
2. Press Softkey 3 while you switch on the power.
3. Release Softkey 3 when the User Progr. Parameters menu is displayed.
4. Press Softkey 5, Printer, to display the Printer Options. This menu gives
access to five sub-menus.
5. Press Softkey 1, Select, to display the Select Printer menu.
26