Turn off device screen Testing: Audiometry Connect the headphones to the blue connector. Select the Audiometry: Screening button from the start menu. Select the ear on which you want to start the test. Otometrics - Next generation Bio-logic products...
Once all frequencies have been tested for one identified, move on Tap three times to get ear, you can test the other ear. to the next frequency. back to a blank square. Otometrics - Next generation Bio-logic products...
Page 4
Select the test ear by pressing either the Right or Left button. Select cartoon mode to show balloons when the test is finished. Otometrics - Next generation Bio-logic products...
Page 5
Switch to results of the other ear after both ears Note: These circles indicate that have been tested other screens are available to view. Swipe your finger right or left to get other views Otometrics - Next generation Bio-logic products...
Page 6
OAE and audiometry screening ® ® Detailed results view Red or blue bars indicate Outcome for each test sorted by Numeric values shown in table response, grey bars indicate noise f2 and L2 format Otometrics - Next generation Bio-logic products...
Need help?
Do you have a question about the Bio-logic AuDX and is the answer not in the manual?
Questions and answers