Summary of Contents for otometrics Bio-logic NavPRO ONE
Page 1
Bio-logic ® Bio-logic NavPRO ONE ® ® ASSR Quick Start Guide Doc. No.7-26-1389-EN/00 Part No.7-26-13809-EN Natus Medical Denmark ApS. +45 45 75 55 55. otoinfo@natus.com Natus Medical Incorporated. 1-800-289-2150. otoorder.us@natus.com www.otometrics.com...
Page 2
Start menu Note: this screen (test options) can vary depending on your set up Battery status Current time Select patient Customize settings Additional information about options for Turn off device current screen Otometrics - Next generation Bio-logic products...
Page 3
Clean the patient’s skin and place the electrode pads. Connect the clips to the corresponding sites. Recommended montage is: White: high forehead Black: cheek Red: mastoid For binaural testing, place red electrode on the nape. Otometrics - Next generation Bio-logic products...
Page 4
Select start, minimum and Select masking noise 40 Hz: awake and adult patients maximum level for adaptive (monaural testing only) 80 Hz: babies and higher frequencies mode Auto: mixed rate, optimized for performance Otometrics - Next generation Bio-logic products...
Page 5
4 k ohm. If impedance is higher than 6 k ohm but below 12 k ohm, a skip button will become available. An impedance below 6 k ohm is recommended for best test results. Otometrics - Next generation Bio-logic products...
Page 6
Intensity level being tested Overall EEG, – value should remain in the lower third. Press Impedance monitor to enable raw EEG view Test progress Stop test Pause ongoing test Skip this single test Otometrics - Next generation Bio-logic products...
Page 7
Swipe your finger right or left to get other views. Press on a check mark Test conditions or circle to view details Otometrics - Next generation Bio-logic products...
Need help?
Do you have a question about the Bio-logic NavPRO ONE and is the answer not in the manual?
Questions and answers