Setting Up Test Parameters; Preprogrammed User Tests; Manual Setup By Menu - otometrics Madsen Midimate 602 Quick Manual

MIDIMATE 602 & 622 Diagnostic Audiometers

3 Setting Up Test Parameters

Use the MIDIMATE 602/622 to test patients with one of five pre-programmed User
Tests (§3.1), or with a manual setup by menu (§3.2). MIDIMATE 622 may be set up
to store and display for viewing and/or print out thresholds as described in §8.2.
3.1

Preprogrammed user tests

MIDIMATE 602/622 is delivered with Tests 1 to 3 pre-programmed with typical
setups for Tone/Air (§4.1), Tone/Bone (§4.2) and Speech testing with recorded
speech (§5.2). To change the setup of these tests and pre-program Tests 4 and 5 see
Chapter 7.
To select one of the other User Tests, do as follows:
1. Press Menu until Select User Test is displayed.
2. Press the Softkey corresponding to the required User Test.
3. If required, hold down the selected Softkey to interrupt the automatic setup se-
quence. When the sequence is completed the MIDIMATE 602/622 is ready for
testing.
3.2

Manual setup by menu

To set up the test parameters manually, do as follows. To backstep in this procedure,
press Menu instead of a Softkey.
1. Press Menu to display the Select Function screen. The upper line shows the
current function and the lower line shows the options you can select by pressing
the Softkeys.
2. Press Softkey 1, 2 or 3 to select the Function (Tone, Speech or Special) with
its corresponding Output screen.
3. Press Softkey 1, 2 or 3 to select the Output (Air, Bone or F.F.) and display the
Stimulus Side screen.
4. Press Softkey 1, 2 or 3 to select the Stimulus Side (Left, Right or L+R) and
display the corresponding Masking screen, or Input screen in the case of
Speech.
5. If you selected Speech in step 0, press Softkey 1 or 2 to select the required Input
(Tape (CD) or Micr.) with its corresponding Masking screen.
6. Press Softkey 1, 2, 3 or 4 to select the type of Masking (No Mask, Air, Ipsi or
Bin. S+M) and to see a list of the selections made (including a reference number
for the selected setup).
7. After a few moments the default settings for the selected test are shown. If re-
quired, change any of these settings by toggling the corresponding Softkey.
9