AEG BEB351110B User Manual page 30

30 www.aeg.com
Problem
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
There is no good cooking
performance using the func-
tion: True Fan Cooking
PLUS.
There is no good cooking
performance using the func-
tion: True Fan Cooking
PLUS.
There is no good cooking
performance using the func-
tion: True Fan Cooking
PLUS.
You want to activate the
True Fan Cooking function,
but the indicator of the Plus
Steam button is on.
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
Possible cause
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
You did not turn on the func-
tion: True Fan Cooking
PLUS.
You did not turn on correctly
the function: True Fan Cook-
ing PLUSwith the Plus Steam
button.
You did not fill the cavity
embossment with water.
The True Fan Cooking PLUS
function operates.
The temperature is too low.
There is too much water in
the cavity embossment.
on the front frame of the oven cavity. Do
not remove the rating plate from the
oven cavity.
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Activating the
function: True Fan Cooking
PLUS".
Refer to "Activating the
function: True Fan Cooking
PLUS".
Refer to "Activating the
function: True Fan Cooking
PLUS".
Push the Plus Steam button
to stop the True Fan
Cooking PLUS function.
Set the temperature at least
to 110 °C.
Refer to "Hints and tips"
chapter.
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to the specific procedure.