Figure 4-7: Tighten The Shaft Coupling To The Drive Screw - Aerotech PRO560SL Hardware Manual

4.3. Motor Mounting
7. Tighten the Shaft Coupling to the drive screw
and torque requirements.
8. Rotate the drive screw by hand to ensure that the drive screw rotates freely.
IMPORTANT: You must reapply Loctite to the mounting hardware if the Motor or Shaft
Coupling screws are removed, adjusted, loosened, or replaced.
50
Figure 4-7: Tighten the Shaft Coupling to the Drive Screw
PRO560SL/SLE Hardware Manual
(Figure 4-7). Refer to Table 4-1 for the correct hardware
www.aerotech.com