Motor Mounting; Figure 4-4: Motor Mounting Overview; Table 4-1: Hardware Requirements - Aerotech PRO560SL Hardware Manual

4.3. Motor Mounting

4.3. Motor Mounting
DANGER: To decrease the risk of electrical shock, injury, death, and damage to the
equipment, obey the precautions that follow.
Do not connect or disconnect electrical components, wires, and cables while this product
l
is connected to a power source.
Before you do maintenance to the equipment, disconnect the electrical power.
l
Uncouple or otherwise prevent motor-coupled machinery movement when you do ser-
l
vice to the equipment.
Table 4-1: Hardware Requirements
Stage
PRO560SL/SLE
IMPORTANT: Use Loctite 242 or Loctite 248 on the motor and coupling adapter hardware
(Figure
the expiration date is legible and the product has not expired.
If your stage is used in a vacuum or cleanroom environment, contact Aerotech.
How to Mount a Motor
1. Remove the hard cover from the stage.
2. Locate the Shaft Coupling access holes (refer to
3. Test fit the Motor and Shaft Coupling to the Stage to ensure that you have access to the Shaft
Coupling clamp screws.
4. Apply a small quantity of either Loctite 242 or Loctite 248 to motor and coupling hardware.
5. Attach the Shaft Coupling to the Motor shaft (refer to
hardware and torque requirements.
48
Motor
Screw Size
M5
4-4). Loctite products are printed with an expiration date. Before use, be sure that
Figure 4-4:
PRO560SL/SLE Hardware Manual
Shaft Coupling Coupling Screw
Screw Size
M4 3 mm Hex
Motor Mounting Overview
Figure 4-4).
Figure 4-5). Refer to
Coupling Screw
Bit Size Torque
44 in·lbs
Table 4-1 for the correct
www.aerotech.com