Measurement Using the Trigger Control Fields:
•
From Controls select the desired trigger source:
•
Internal uses the signal being displayed.
•
Ext (TTL) uses the signal connected to the rear panel EXT SCOPE
TRIGGER INPUT connector.
•
Encoder uses the optional signaling encoder.
•
Trigger mode is selected as follows:
•
In Auto, a trigger is automatically generated every 50ms (unless a
normal trigger is received).
•
In Norm, a defined trigger required.
•
In Cont, the oscilloscope sweeps on each trigger occurrence.
•
In Single, the oscilloscope sweeps once on a trigger occurrence af-
ter Reset is selected.
•
Level (div) sets the internal trigger level (vertical divisions). Pos selects
triggering for positive going signals. Neg selects triggering for negative
going signals. Pointer indicates level.
•
Pre-Trig sets the number of horizontal divisions to be displayed prior
to the trigger. Pointer indicates pre-trigger point.
Indicators:
•
Marker Time ms changes the units that the marker position is dis-
played in. Displayed value is the time elapsed from the trigger point
to the current position.
•
Marker Lvl V/kHz/% changes units that the marker position is dis-
played in. Displayed value is signal level at current position.
Using the Oscilloscope
239