Table of Contents
Advertisement
Quick Links
INSTALLATION, OPERATION & MAINTENANCE MANUAL
IMPORTANT!
Read all instructions in this manual before operating pump.
As a result of Crane Pumps & Systems, Inc., constant product improvement program,
product changes may occur. As such Crane Pumps & Systems reserves the right to
change product without prior written notifi cation.
A Crane Co. Company
420 Third Street
Piqua, Ohio 45356
Phone: (937) 778-8947
Fax: (937) 773-7157
www.cranepumps.com
Manual Index
DEMING
DEMING
Vertical Process Pumps
83 West Drive, Bramton
Ontario, Canada L6T 2J6
Phone: (905) 457-6223
Fax: (905) 457-2650
®
Series: 5411
5421
5421-H
Form No. 120023-Rev. D
Advertisement
Table of Contents
Related Manuals for Crane DEMING 5411 Series
Summary of Contents for Crane DEMING 5411 Series
- Page 1 Read all instructions in this manual before operating pump. As a result of Crane Pumps & Systems, Inc., constant product improvement program, product changes may occur. As such Crane Pumps & Systems reserves the right to change product without prior written notifi cation.
-
Page 2: Table Of Contents
CROSS-SECTION & PARTS LIST ...........7 - 8 WARRANTY & RETURNED GOODS ..........11 Other brand and product names are trademarks or registered trademarks of their respective holders. Deming® is a registered trademark of Crane Pumps & Systems, Inc. 1997, 10/06 Alteration Rights Reserved... -
Page 3: Safety First
Crane Pumps & Systems, Inc. is not responsible for WARNING ! Do not pump hazardous materials losses, injury, or death resulting from a failure to observe (fl... -
Page 4: General Information
Systems Service Department in Piqua, Ohio, telephone rotate clockwise looking down on the motor. (Left hand (937) 778-8947 or Crane Pumps & Systems Canada, Inc., pumps operate in reverse direction.) Bramton, Ontario, (905) 457-6223. -
Page 5: For Inspection Or Repair Of Liquid End
E - TO INSPECT OR REPLACE BALL A lithium base grease of medium consistency with BEARINGS & SEAL corrosion resistant inhibiting properties must be used for the ball bearings. Shell Alvania #2 or equivalent is recommended. Remove electric wires from motor. Then remove 4 bolts and lift drive pedestal (081) motor and top half of coupling (042) from frame (019). -
Page 6: Assembly Of Liquid End
G - ASSEMBLY OF LIQUID END Replace bearing cover, motor and coupling. Align coupling and proceed with installation as described Slide defl ector (040) over shaft, but do not adjust. in that section Place throttle housing (099) over end of the shaft and against fl... - Page 8 ITEM No. DESCRIPTION ITEM No. DESCRIPTION Casing Discharge Pipe Impeller Set Screw Shaft Cap Screw Suction Cover Cap Screw *016 Ball Bearing (Inboard) Cap Screw *018 Ball Bearing (Outboard) Cap Screw Frame Cap Screw Base Plate Grease Fitting *024 Impeller Nut Hex Nut Impeller Key Throttle Bushing...
- Page 10 Crane Pumps & Systems, Inc. Distributor. RETURNED GOODS RETURN OF MERCHANDISE REQUIRES A “RETURNED GOODS AUTHORIZATION”. CONTACT YOUR LOCAL CRANE PUMPS & SYSTEMS, INC. DISTRIBUTOR. Products Returned Must Be Cleaned, Sanitized, Or Decontaminated As Necessary Prior To Shipment, To Insure That Employees Will Not Be Exposed To Health Hazards In Handling Said Material.
Need help?
Do you have a question about the DEMING 5411 Series and is the answer not in the manual?
Questions and answers