Programming The Analog Meas Screen - HP 8921A Programmer's Manual

Chapter 8, Programming The Call Processing Subsystem

Programming The ANALOG MEAS Screen

Programming The ANALOG MEAS Screen
Figure 56 The ANALOG MEAS Screen
Requirements for Using The ANALOG MEAS Screen
532
The screen is used to make RF and audio measurements on the
ANALOG MEAS
mobile station connected to the Test Set while on an active voice channel.
Refer to Chapter 6, "Call Processing Subsystem", in the HP 8920 User's Guide
for detailed information on the operation and manual use of the
screen. The information presented in this section covers the
programming commands and how to use them.
The Test Set must be in the connected state (that is, the
lit) in order to use the ANALOG MEAS screen.
The mobile station's speaker output must be connected to the Test Set's AUDIO
IN connector and the mobile station's microphone input must be connected to the
Test Set's AUDIO OUT connector in order to use the ANALOG MEAS screen.
ANALOG MEAS
screen
ANALOG MEAS
annunciator is
Connect