HP 8921A Programmer's Manual page 339

External Disk Drive
TESTS Subsystem
Selecting the Mass Storage Location
The default mass storage volume specifier for the external disk drive is set using
the
External Disk Specification
screen.
The default mass storage location for the TESTS Subsystem is set using the
Select Procedure Location:
default mass storage volume specifiers for the TESTS Subsystem mass storage
locations are as follows:
• Card selection (not changeable) - ":INTERNAL,4"
• ROM selection (not changeable) - ":MEMORY,0,4"
• RAM selection (not changeable) - ":MEMORY,0,0"
• Disk selection - the External Disk Specification field in the TESTS
(External Devices) screen.
The IBASIC mass storage location is selected using the IBASIC Mass Storage Is
command. The mass storage volume specifier for the desired mass storage
location is appended to the Mass Storage Is command. Refer to the HP Instrument
BASIC User's Handbook for further information regarding the Mass Storage Is
command.
For example, to change the default mass storage location to RAM Disk unit 2,
execute the following command:
Mass Storage Is ":MEMORY,0,2"
The Mass Storage Is command is keyboard and program executable; however,
any changes made are lost when the Test Set is turned off or when the SERVICE
screen's
RAM Initialize
Chapter 6, Memory Cards/Mass Storage
field in the TESTS (External Devices)
field on the TESTS (Main Menu) screen. The
function is executed.
Default Mass Storage Locations
339