Table of Contents
Advertisement
Chapter 7, IBASIC Controller
Method #1. Program Development on an External BASIC Language Computer
HP BASIC for Windows PC Configuration for Windows NT Operating System
386
To prepare for HP BASIC program development utilizing Windows NT, the
external PC must be configured to operate with the Test Set.
You will need:
•
an HP 82341B/C interface card (the HP 82335 card does not support Windows NT)
•
a licensed version with security key of HP BASIC for Windows. You can get the latest
files from ftp://hpislsup.lvld.hp.com/pub/pc/index.html. Select the HP BASIC for
windows archives and follow the instructions for download.
How to install:
1. Install the HP 82341B/C into an open expansion slot. Refer to the interface card's in-
stallation guide details. Utilize the default card settings.
2. Install the SICL libraries using the SETUP32.EXE setup file.
3. Run the SICL I_O Config program to configure the card.
4. Select HP 82340/82341 HP-IB from the available interface list of choices.
5. Select the Configure command button. Use the default settings shown by the program.
This will verify that the card is functioning.
6. Install HP BASIC for Windows 6.3 or later.
7. Run HP BASIC for Windows.
8. Edit the AUTOST file, change line 330 as follows:
LOAD BIN "HPIBS;DEV hpib7" !SICL Library for HP 82341 card
9. Re-store the AUTOST file
10. Quit HP BASIC for Windows
11. Run HP BASIC for Windows. The program should load normally and allow you to send
orders to the Test Set.
- Quick Links:
- Hp-Ib Commands
Hide quick links:
Advertisement
Table of Contents
