Telestar S 410i HD Plus User Manual page 69

Note: Using this option will delete all data stored in the channel lists, and favourite lists.
After this, the "Installation Wizard" will be open. Please refer to the Installation Wizard section of this user manual
for further information.
Preprogrammed Channel Lists
Use this option to reset your TV channel lists to the receiver's preprogrammed default program lists or to
download an up-to-date channel list over the internet.
SySTEM UPDATE
This option supports three ways to update the software of the digital receiver: Over The Antenna (OTA), through
the USB port or over the internet. When this option is executed, the receiver will automatically search for new
software version at three sources in the following order - (a) on a USB disk, (b) over the internet and (c) over the
satellite. As soon as identifying the first source containing a newer software version, the receiver will reboot into
a software download mode and will start downloading the new software from the identified source. In order to
update from a USB disk, you need to download the updated software file from our website to the root directory on
the USB disk first.
The USB disk should be plugged in the USB port before executing the System Update option. Do not remove
the USB disk until the complete software update process is completed. In order to update over the internet, the
receiver must be connected to the internet over a LAn or WiFi connection. Remove any USB device from the USB
port before you execute the System Update option. If the System Update option is executed but there is no USB
disk connected and no internet connection, the receiver will search for a newer software version over the satellite.
This procedure may take very long time depending on the size of the new software file and therefore it is
recommended to use the USB or internet methods described above for software updates.
After the new software file was downloaded, the receiver will store the new software and automatically restart. All
user preferences and channel lists will remain unchanged.
Caution: Be careful not to interrupt the software update process by removing the USB stick, disconnecting the
internet or turning off the receiver, or otherwise interrupting the installation process. If the installation is interrupted
by accident, such as by a power failure, the receiver may not boot up properly afterwards.
SySTEM InFORMATIOn
This menu displays information related to the software and hardware version of the receiver. This information may
be required if you request service or repair.
AUDIO/VIDEO SETTInGS
This is where you can set the basic audio and video parameters of your digital receiver related to connections on
rear panel.
69