Setup - Telestar S 410i HD Plus User Manual

Setup

This section explains the most important functions to ensure that you can directly watch television with your new
digital receiver. Please note, additional adjustments may be required.
Note: Do not connect the digital receiver to the main power yet.
connecting the Antenna and LnB (Low noise Block) to the digital satellite receiver input
connect the LnB on the satellite dish antenna directly to the digital receiver using the "LnB in" connector of the
receiver, by means of a coaxial cable. you may use the loop-through connector to connect to a second receiver.
connecting the TV set
The digital receiver and TV set can be connected by means of analog A/V cable (not supplied) or HDMI cable.
Simply connect the two ends of the cable you select to use in connecting the receiver to the TV set.
The HDMI connection is recommended for HDTV. In case the TV has a HDMI input connector, a special all-digital
interface that provides the highest picture quality, connect the product to the TV with the HDMI cable.
connecting the network
The receiver connects to the internet through the internet router or DSL/cable modem in your home network. The
receiver can connect connect to the home network over its Ethernet port - through direct connection to the router,
over PLc (Power Line communication) adapters or compatible USB WiFi adapters.
1. Connecting via the Ethernet port:
connect one end of the Ethernet cable to the receiver and the other end to the LAn port at the router or DSL/
cable modem.
2. Connecting via a compatible USB WiFi adapter:
connect the USB adapter to one of the USB ports on the back panel of the receiver. On the network menu,
set the options for the Wi-Fi as follows:
•
network name (SSID): Select the network name of your Wi-Fi access point from the list.
•
Security Type (WEP, WPA, WPA2): The receiver supports WEP 40/128bit AScII, WEP 40/128bit HEX,
WPA and WPA2. The settings of the security type of the Wi-Fi and the receiver shall be the same.
•
Password: When using the security type, you must set the password. Enter the same password in the
Wi-Fi setting menu.
Note: To improve quality of service, keep the distance between the Wi-Fi access point and the receiver close.
connection to a DVD recorder or video recorder
The DVD recorder or video recorder may be connected to the receiver via the cVBS video and analogue stereo
audio outputs.
Note: The A/V output of the DVD recorder or VcR needs to be connected to the TV directly and cannot be
connected to the receiver.
connection to a hi-fi system
The audio quality of digital TV and radio programmes can be enjoyed even more when reproduced through a hi-fi
audio system. To do this, use a RcA cinch stereo cable to connect the sockets marked Audio L/R on the receiver
to one of the inputs of your hi-fi system marked either Line, Aux or Extra.
If your hi-fi system is equipped with a digital audio input, you may use a digital RcA cinch cable to connect the
electrical (coax) digital audio output of your receiver (socket SPDIF) to your hi-fi or Dolby Digital system.
The receiver is also equipped with an optical digital output. If your hi-fi system is equipped with an optical audio
input, you may use an optical cable to connect your hi-fi system to your digital receiver.
connection to main power supply
After all the connections are done you can connect your digital receiver to power using the supplied external Ac/
Dc adapter. Just before plugging the Ac/Dc adapter into the wall socket put the power switch, on the rear panel,
in position 0 (off).
53