Error Code Display And Solutions - Royal Sovereign RBC-ED350 Owner's Manual

ERROR CODE DISPLAY AND SOLUTIONS

The display may show some error codes when counting, which means there are some problems with the
machine. Refer to the chart below to solve the errors.
Error Code
CODE CE02
START CE04
CLEAR CE05
IRL CE06
IRR CE08
UV ERROR
MG ERROR
DOUBLE ERROR
WIDTH ERROR
HALF ERROR
CHAIN ERROR
If you are receiving error codes above, check the machine for dust. If you continue to receive error codes, please
contact Royal Sovereign's Service Center at 1-800-397-1025.
9
Reason
Code disc sensor is dirty or broken.
Hopper sensor is dirty or broken.
Stacker sensor is dirty or broken.
The left counting sensor is dirty or broken.
The right counting sensor is dirty or broken.
UV sensitivity light is too high.
Suspect bill is detected without UV.
Suspect bill detected without MG.
The last counted bill is a double note.
The bill width size is over 8mm difference to the real
USD bill size.
A half bill is counted.
The counting sensor is dirty or broken.
Chain bill is detected.
Solutions
Clean the sensor or contact Royal
Sovereign.
Clean the sensor or contact Royal
Sovereign.
Clean the sensor or contact Royal
Sovereign.
Clean the sensor or contact Royal
Sovereign.
Clean the sensor or contact Royal
Sovereign.
Lower the UV sensitivity. Remove first bill
from the stacker, then continue counting.
Remove first bill from the stacker, then
continue counting.
Remove first bill from the stacker, then
continue counting.
Remove jammed bill from the machine,
then continue counting.
Remove first bill from the stacker, then
continue counting.
Remove first bill from the stacker, then
continue counting.