Preparations; Assembly And Setting Up - Lauda Alpha Operating Instructions Manual

6

Preparations

6.1

Assembly and Setting Up

Do not connect with power mains before assembly and setup is complete!!
R
20 / 54
Place the unit on a flat surface. If necessary, attach the
appropriate pump outflow reducer R onto the pump
nozzle. In small baths use the pressure reducer to pre-
vent any splashing of heat transfer liquid.
Immersion/Heating thermostats only:
Fix the clamp at the bottom of the control head by two
screws M4 x 6 A3 (1.4541) ISO 7046 (recessed
countersunk flat heads).
Accessory "cooling coil set":
Fix the cooling coil set at the bottom of the control head
by means of the two screws (pan head with cross recess).
The cooling coil set belongs to the left side of the head.
Alpha 09/2020 j