Getting Started; Installing The Rubber Bumpers; Removing The Rubber Bumpers; Using The Power Switch - Advantech S10A User Manual

Getting Started

Installing the Rubber Bumpers

To protect the housing case of S10A, install the rubber bumpers.
1. Install the rubber bumpers
on the left and right side of
S10A.
2. Make sure the rubber
bumpers are aligned and
locked on the indents.

Removing the Rubber Bumpers

From the rear of the tablet
PC, remove the rubber
bumpers.

Using the Power Switch

The power switch, located next to the
external battery contacts, controls the
flow of power of your S10A. By default,
the power switch is set on the left.
To reveal the power switch, remove the external battery
contacts cover.
• To cut off power flow - switch to the left
• To allow power flow - switch to the right
S10A User Manual
S1
F1 F2 F3 ENTER
MODE
Lock Lock
SW1
S2
8