Smeg CMSCU451S Instructions Manual page 12

x 16
x 2
x 16
x 2
Position the rails on the sides of the cabinet as shown in the
figure.
Fix with the screws, then extract them completely.
If the coffee maker is installed over a warmer drawer (500 W
max.), use the top surface of this as a reference to position the
rails.
x 1
In this case, there will be no surface to rest the rails on.
x 1
x 1
Fix the power cable with the clip to avoid it tangling when the
appliance is inserted or extracted.
The power cable must be long enough to allow the appliance to
be extracted from the cabinet to fill the coffee beans container.
The appliance must be earthed in compliance with legislation.
Electrical connections must be performed by a qualified elec-
trician in compliance with the manufacturer's instructions and
legislation in force in the country of installation.
The electrical socket must be accessible.
x 2
x 2
x 1
x 4
x 4
Position the appliance on the rails, making sure the pins are
correctly inserted in the housings, then fix it with the screws
supplied.
x 4
x 4
If necessary, correct alignment of the appliance by positioning
the spacers supplied under or at the sides of the support.
11
x 4
x 4
x 4
x 4