Installation - Procom Blue Flame Manual

INSTALLATION

NOTICE: This heater is intended for use as supplemental heat. Use this heater along with your primary heating
system. Do not install this heater as your primary heat source. If you have a central heating system, you may
run system's circulating blower while using heater. This will help circulate the heat throughout the house. In the
event of a power outage, you can use this heater as your primary heat source.
CAUTION: If you install the heater in a home garage:
• Heater pilot and burner must be at least 18 inches above the floor.
• Place heater where moving vehicle will not hit it.
WARNING: A qualified service person must install heater. Follow all local codes.
WARNING: Never install the heater
• in a bathroom - Model #MD100TBA and MD100HBA
• in a bedroom or bathroom - Model #MD200TBA, MD200TBA-BB MD200HBA, MD200HBA-BB, MD300TBA,
MD300TBA-BB, MD300HBA and MD300HBA-BB
• in a recreational vehicle
• where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or
sides of the heater
• in high traffic areas
• in windy or drafty areas
CAUTION: This heater creates warm air currents. These currents move heat to wall surfaces next to heater.
Installing heater next to vinyl or cloth wall coverings or operating heater where impurities (such as tobacco
smoke, aromatic candles, cleaning fluids, oil or kerosene lamps, etc.) in the air exist, may cause walls to discolor.
IMPORTANT: Vent-free heaters add moisture to the air. Although this is beneficial, installing heater in rooms
without enough ventilation air may cause mildew to form too much moisture. See Air for Combustion and
Ventilation, pages 9 through 11.
Check Gas Type
Be sure your gas supply is right for your heater.
Otherwise, call dealer where you bought the
heater for proper type heater.
Clearances To Combustibles
Carefully follow the instructions below. This
heater is designed to be mounted on a wall or
set directly on the floor using approved base.
WARNING: Maintain the minimum clearances
shown in Figure 4. If you can, provide greater
clearances from floor, ceiling, and joining wall.
LOCATING HEATER
For convenience and efficiency, install heater:
1) where there is easy access for operation,
inspection, and service.
2) In the coldest part of room.
Figure 4 - Mouting clearances as viewed from
front of heater (inches)
12 12