Table of Contents
Advertisement
Configuring Content Clustering
Using the CLI to configure Transparent mode
Backing up and resturing content cluster configurations and
upgrading content cluster firmware
FortiSwitch-5203B Security System Guide
01-520-145204-20151108
http://docs.fortinet.com/
Backing up and resturing content cluster configurations and upgrading content cluster firmware
To change the management interface
1 Go to System > Config > Operation.
2 Enter the Management IP address and netmask.
To configure the Primary and Secondary DNS server IP addresses
1 Go to System > Network > Options.
2 Enter the Primary and Secondary DNS IP addresses.
1 Use the serial cable supplied with your FortiSwitch-5203B board to connect a
management computer to the Console port.
2 Start a terminal emulation program (HyperTerminal) on the management computer.
Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control None.
3 At the Login: prompt, type admin and press Enter twice (no password required).
4 Change from NAT/Route mode to Transparent mode. Configure the Management IP
address and default gateway.
config system settings
set opmode transparent
set manageip <mng_ip>/<netmask>
set gateway <gateway_ip>
end
5 Configure the primary and secondary DNS server IP addresses.
config system dns
set primary <dns-server_ip>
set secondary <dns-server_ip>
end
Fortinet periodically updates FortiOS firmware to include enhancements and address
issues. After you have registered the boards in your content cluster (see
FortiSwitch-5203B" on page
FortiSwitch-5203B and for the workers from the support web site
http://support.fortinet.com
content cluster.
The firmware running on the FortiSwitch-5203B is FortiOS firmware. You can download
the latest FortiSwitch-5203B firmware from the same location as other FortiOS firmware
(including worker firmware). All boards in a cluster must be running the same version of
FortiOS.
You can upgrade the FortiSwitch-5203B firmware from the FortiSwitch-5203B
web-based manager or CLI. You must upgrade the FortiGate-5001B firmware from the
FortiSwitch-5203B CLI. The recommended procedure is to upgrade the FortiGate-5001B
worker firmware first and then upgrade the FortiSwitch-5203B firmware. Use the
FortiSwitch-5203B mgmt interface as the network connection for firmware upgrades.
25) you can download FortiOS firmware for the
and then upgrade the firmware running on the boards in your
"Registering your
37
Advertisement
Table of Contents
