Table of Contents
Advertisement
Upgrading FortiGate-5001D firmware
Using the CLI to configure Transparent mode
Upgrading FortiGate-5001D firmware
32
To change the management IP address
1 Go to System > Dashboard > Status and select the Change link beside Operation
Mode: Transparent.
2 Change the Management IP/Netmask to the address and netmask hat you added to
Table 9 on page 31
and select Apply.
To configure the Primary and Secondary DNS server IP addresses
1 Go to System > Network > DNS.
2 Enter the Primary and Secondary DNS IP addresses that you added to
page 31
as required and select Apply.
1 Use the serial cable supplied with your FortiGate-5001D board to connect the
FortiGate-5001D Console port to the management computer serial port.
2 Start a terminal emulation program (HyperTerminal) on the management computer.
Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control None.
3 At the Login: prompt, type admin and press Enter twice (no password required).
4 Change from NAT/Route mode to Transparent mode. Configure the Management IP
address and default gateway to the settings that you added to
config system settings
set opmode transparent
set manageip <mng_ip>/<netmask>
set gateway <gateway_ip>
end
5 Configure the primary and secondary DNS server IP addresses to the settings that
you added to
Table 9 on page
config system dns
set primary <dns-server_ip>
set secondary <dns-server_ip>
end
Fortinet periodically updates the FortiGate-5001D FortiOS firmware to include
enhancements and address issues. After you have registered your FortiGate-5001D
security system you can download FortiGate-5001D firmware from the support web site
http://support.fortinet.com.
Only FortiGate-5001D administrators (whose access profiles contain system read and
write privileges) and the FortiGate-5001D admin user can change the FortiGate-5001D
firmware.
To upgrade the firmware using the web-based manager
1 Copy the firmware image file to your management computer.
2 Log into the web-based manager as the admin administrator.
3 Go to System > Dashboard > Status.
4 Under System Information > Firmware Version, select Update.
31.
FortiGate-5001D Security System Guide
Quick Configuration Guide
Table 9 on
Table 9 on page
31.
01-500-0242101-20151109
http://docs.fortinet.com/
Advertisement
Table of Contents
