Table of Contents
Advertisement
Hardware installation
Inserting a FortiSwitch-5203B board
FortiSwitch-5203B Security System Guide
01-520-145204-20151108
http://docs.fortinet.com/
Figure 7: FortiSwitch-5203B right (bottom) mounting components
Retention
Lock
Handle
Hook
Lock
Handle
The FortiSwitch-5203B handles align the board in the chassis slot and are used to insert
and eject the board from the slot. The right (bottom) handle activates a microswitch that
turns on or turns off power to the board. When the right (bottom) handle is open the
microswitch is off and the board cannot receive power. When the right (bottom) handle is
fully closed the microswitch is on and if the board is fully inserted into a chassis slot the
board can receive power.
You can reset the board without removing it from the chassis. See
FortiSwitch-5203B board" on page
The FortiSwitch-5203B board must be fully installed in a chassis hub/switch slot (usually
slot 1 or 2), with the handles closed and locked and retention screws fully tightened for
the FortiSwitch-5203B board to receive power and operate normally. If the
FortiSwitch-5203B board is not receiving power, the HS LED glows solid blue and all
other LEDs remain off. See
It is important to carefully seat the FortiSwitch-5203B board all the way into the chassis,
to not use too much force on the handles, and to make sure that the handles are properly
locked. Only then will the FortiSwitch-5203B board power-on and start up correctly.
FortiSwitch-5203B boards are hot swappable. The procedure for inserting
a FortiSwitch-5203B board into a chassis slot is the same whether or not the chassis is
powered on.
Closed
Alignment
Pin
Screw
Open
Alignment
Pin
Handle
Retention
Screw
22.
"Front panel components" on page
Inserting a FortiSwitch-5203B board
Alignment Pin
Retention
Screw
Handle
Lock
Alignment Pin
Retention
Screw
Lock
Hook
"Power cycling a
6.
17
Advertisement
Table of Contents
