Table of Contents
Advertisement
Configuring Content Clustering
Using the web-based manager to configure NAT/Route mode
Using the CLI to configure NAT/Route mode
FortiSwitch-5203B Security System Guide
01-520-145204-20151108
http://docs.fortinet.com/
1 Connect port1 of the FortiSwitch-5203B MGMT interface to the same hub or switch
as the computer you will use to configure the board.
2 Configure the management computer to be on the same subnet as the MGMT
interface of the FortiSwitch-5203B board. To do this, change the IP address of the
management computer to 192.168.1.2 and the netmask to 255.255.255.0.
3 To access the web-based manager, start a web browser and browse to
https://192.168.1.99 (remember to include the "s" in https://).
4 Type admin in the Name field and select Login.
To change the admin administrator password
1 Go to System > Admin > Administrators.
2 Select Change Password for the admin administrator and enter a new password.
To configure interfaces
1 Go to System > Network > Interface.
2 Select the edit icon for each interface to configure (interfaces F1 to F8).
3 Set the addressing mode for the interface. (See the online help for information.)
• For manual addressing, enter the IP address and netmask for the interface.
• For DHCP addressing, select DHCP and any required settings.
• For PPPoE addressing, select PPPoE and enter the username and password and
any other required settings.
To configure the Primary and Secondary DNS server IP addresses
1 Go to System > Network > Options.
2 Enter the Primary and Secondary DNS IP addresses and select Apply.
To configure the Default Gateway
1 Go to Router > Static and select Edit icon for the static route.
2 Select the Device that you recorded above.
3 Set Gateway to the Default Gateway IP address.
4 Select OK.
1 Use the serial cable supplied with your FortiSwitch-5203B board to connect a
management computer to the Console port.
2 Start a terminal emulation program (HyperTerminal) on the management computer.
Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control None.
3 At the Login: prompt, type admin and press Enter twice (no password required).
4 Change the administrator password.
config system admin
edit admin
set password <password>
end
Configuring NAT/Route mode
35
Advertisement
Table of Contents
