Table of Contents
Advertisement
Shutting down and Removing a FortiSwitch-5203B board
Shutting down and Removing a FortiSwitch-5203B board
20
Table 5: FortiSwitch-5203B normal operating LEDs
LED
State
OOS
Off
Power
Green
Status
Off
Off (Or flashing green when the system accesses the
ACC
FortiSwitch-5203B flash disk.)
IPM
Off
If the board has not been inserted properly the HS LED changes to solid blue and all
other LEDS turn off. If this occurs, open the handles, slide the board part way out, and
repeat the insertion process.
9 Once the board is inserted correctly, fully tighten the retention screws to lock the
FortiSwitch-5203B board into position in the chassis slot.
Tighten
To avoid potential hardware problems, always shut down the FortiSwitch-5203B
operating system properly before removing the FortiSwitch-5203B board from a chassis
slot or before powering down the chassis.
The following procedure describes how to correctly use the FortiSwitch-5203B mounting
components described in
remove a FortiSwitch-5203B board from an ATCA chassis slot.
FortiSwitch-5203B boards are hot swappable. The procedure for removing
a FortiSwitch-5203B board from a chassis slot is the same whether or not the chassis is
powered on.
To remove a FortiSwitch-5203B board from a chassis slot
Do not carry the FortiSwitch-5203B board by holding the handles or retention screws.
When inserting or removing the FortiSwitch-5203B board from a chassis slot, handle the
board by the front panel. The handles are not designed for carrying the board. If the
handles become bent or damaged the FortiSwitch-5203B board may not align correctly
in the chassis slot.
To complete this procedure, you need:
• An ATCA chassis with a FortiSwitch-5203B board installed
Retention
Screw
"FortiSwitch-5203B mounting components" on page 16
Hardware installation
FortiSwitch-5203B Security System Guide
01-520-145204-20151108
http://docs.fortinet.com/
to
Advertisement
Table of Contents
