Table of Contents
Advertisement
Configuring Transparent mode
Configuring Transparent mode
Using the web-based manager to configure Transparent mode
36
5 Configure the F1 interface.
config system interface
edit f1
set ip <intf_ip>/<netmask_ip>
end
6 Repeat to configure other interfaces as required, for example, to configure the F8
interface:.
config system interface
edit f1
...
7 Configure the primary and secondary DNS server IP addresses.
config system dns
set primary <dns-server_ip>
set secondary <dns-server_ip>
end
8 Configure the default gateway.
config router static
edit 1
set device <interface_name>
set gateway <gateway_ip>
end
Use the following procedures to configure an content cluster for Transparent mode
operation. HA synchronizes configuration settings as required so you only have to
change the configuration of the primary FortiSwitch-5203B board.
1 Connect port1 of the FortiSwitch-5203B MGMT interface to the same hub or switch
as the computer you will use to configure the board.
2 Configure the management computer to be on the same subnet as the MGMT
interface of the FortiSwitch-5203B board. To do this, change the IP address of the
management computer to 192.168.1.2 and the netmask to 255.255.255.0.
3 To access the web-based manager, start a web browser and browse to
https://192.168.1.99 (remember to include the "s" in https://).
4 Type admin in the Name field and select Login.
To switch from NAT/Route mode to transparent mode
1 Go to System > Status and select the Change link beside Operation Mode: NAT.
2 Set Operation Mode to Transparent.
3 Set the Management IP/Netmask.
4 Set the default Gateway.
To change the admin administrator password
1 Go to System > Admin > Administrators.
2 Select Change Password for the admin administrator and enter the password.
Configuring Content Clustering
FortiSwitch-5203B Security System Guide
01-520-145204-20151108
http://docs.fortinet.com/
Advertisement
Table of Contents
