Table of Contents
Advertisement
Installation -
Installation
Before installing your camera, you have to read the following cautions.
1.
The mounting surface must bear five times the weight of your camera.
2.
Do not let the cables get caught in improper places or the electric line cover to be damaged. This may cause
a breakdown or fire.
3.
Install the Desi-Pack (moisture absorber) before completing the installation. The accessory Desi-Pack is
provided in a sealed package and is used to prevent moisture (dew formation) caused by water entering the
camera body when the cover is removed in the installation process.
• Remove the Desi-Pack from its shipping packaging.
• Open the camera's control panel located on the side of the camera.
• Place the Desi-Pack in the location shown in the illustration below.
• Close the camera control panel tightly.
Reset to the Factory Default
Press the reset button for 5 seconds to return the
setup to the factory default.
Warning:
If you press the 'Reset' button, you will lose all
setting data. If needed, please, make a note for
further installation.
Test video output
6
SD card slot
Reset button
Advertisement
Table of Contents
