Digital Watchdog MEGApix Pano DWC-MBW8Wi2TW User Manual page 8

8mp ultra-wide view single-sensor ip bullet camera

Table of Contents

Installation -

Installation

Before installing your camera, you have to read the following cautions.

1. Using the mounting template sheet or the camera itself, mark and drill the necessary holes in the wall or

ceiling.

2. Pass the wires through and make all necessary connections. See the next page for more information.

3. Once all cables are connected, secure the camera to the mounting surface using the included screws.

To use the camera's waterproof wiring:

a. Install the LAN cable into (a).

b. (b) will be assembled to (c) with a 1/4 turn.

c. Thread (c) tightly to (b).

NOTE:

To ensure moisture seal, make sure the o-ring is in place

between

and

outdoor rated sealer is recommended.

NOTE:

When using the waterproof cap, crimp the RJ45

connector after passing the cable through the

waterproof cap.

4. Loosen the pan and tilt stopper screw at the base of the camera's bracket to adjust the camera's view and

position.

. In extreme environments use of an

Table of Contents

Megapix pano dwc-mpbw8wi2tw