Environmental Aspects; Packaging; Disposal; Troubleshooting - Bartscher Deltamat TF527 LPR Manual

9. ENVIRONMENTAL ASPECTS

9.1 Packaging

Packaging is made of the following components:
•
•
•
•
•
All above materials, shall be disposed and treated in accordance with the Local Laws in force.

9.2 Disposal

The symbol WEEE/RAEE used on this product indicates that it cannot be treated as domestic waste. Proper
disposal of this product contributes to protecting the environment. For more information on product recycling,
contact the local authorities, domestic waste authorities or the dealer where the product was purchased.
For product or parts disposal, follow the Council directives 2011/65/UE and 2012/19/UE as amended and/or
application legislative decrees.
The present product or parts cannot be disposed of as urban waste but shall be collected in separate containers (see the
waste bin on wheels symbol with an "X" on the product).
At the time of product disposal, the user shall refer to the waste electrical and electronic equipment (WEEE/RAEE) specifi cation.
The manufacturer guarantees the absence of dangerous substances in the EEA used in conformity to the directive 2011/65/UE.
If the user does not comply with the regulations he/she shall be subject to the penalties foreseen by each member state.
Disconnect electricity and water before disposal.
Cut away the electrical cable to ensure that further use is impossible.
All metal parts are recyclable as they are made of stainless steel.
Recyclable plastic parts are marked with the plastic material symbol.

10. TROUBLESHOOTING

Type of Problem
The machine does not
turn on
The machine does not
load water.
The machine loads water
very slowly
Wa s h i n g r e s u l t s a r e
unsatisfactory.
a wooden pallet;
a nylon sack (LDPE);
a multi-layer carton;
polystyrene (PS) strips;
polypropylene (PP) banding.
Possible Causes
Main switch not ON.
Water valve shut.
Rinse nozzles or solenoid-valve
fi lter blocked and/or scaled with
limestone.
Defective pressure-switch.
Scarce water supply pressure
Rinse booster pump blocked (if
installed)
The washing nozzles are obstructed
or the rack does not rotate.
Foam is present
Fats or starches not removed.
Filters are dirty.
Check tank temperature (which
must be between 55°C and 60°C).
Wash time insuffi cient for the type
of dirt.
Wash water is dirty.
Cure
Turn switch ON.
Open the water valve.
Clean the rinse arm nozzles, piping and solenoid-valve fi lter.
If the machine is equipped with a water softener check the
salt content or regenerate the resins more often
Replace pressure-switch.
Check the water supply pressure
Contact Technical Service.
Remove the wash rack and clean the wash nozzles. Check
the right positioning of the wash-arm, tightening fi rmly.
Use no-foam detergents or reduce the dose in use.
Insuffi cient detergent concentration.
Remove fi lters, clean with brush under a jet of water and
replace in original position.
Contact Technical Service.
Select a longer wash-cycle, if possible, otherwise repeat
the wash cycle.
Drain the tank water, clean the fi lters; refi ll the tank and
replace the fi lters correctly.
EN
page 55