Alarms - Bartscher Deltamat TF527 LPR Manual

EN
Rinse-aid level warning (option).
on machines equipped with the optional "Chemicals level Sensor").
Flowmeter failure warning (option).
detected and the inlet water temperature probe is damage or is disconnected (only on machines equipped with the optional
"Flowmeter" installed and enabled, after the water fi lling or the rinse). By pressing both the key
the message Err FLuS appears.
Water probe failure (option).
inlet water temperature (only on machines equipped with the optional "Loading water probe" installed and enabled). If the
water probe is damage or disconnected the message

8.2 Alarms

The alarms are displayed, based upon their meaning.
If an alarm occurs the machine stops.
TYPE OF ALARM
B2
B3
B4
B5
B9
E1
E2
E3
E5
E6
E8
Z6
Z9
page 52
When the F19
When the F9
!
By pressing both the key
CAUSE
BOILER PROBE FAILED
BOILER HEATING ALARM
FAILURE RINSING
BOILER OVERHEATING
BOILER SAFETY THERMOSTAT
WATER LOAD FAILED
TANK PROBE FAILED
TANK HEATING ALARM
TANK OVERHEATING
TANK DRAINING FAILED
TANK SAFETY THERMOSTAT
TANK LOW LEVEL
REGENERATION FAILED
indicator fl ashes on the display it means that the rinse-aid is over (only
symbol appears on the display it means that no passage of water is
A and C for about 3 seconds it is possible to check the machine
FAIL 000°C appears.
A and C for about 10 seconds
!