Bartscher Deltamat TF527 LPR Manual page 53

B2. BOILER PROBE FAILED:
Cause: The circuit board does not detect the boiler sensor.
Remedies: Contact Technical Service.
!
B3. BOILER HEATING ALARM:
Cause: The factory-set boiler temperature was not achieved in the maximum
foreseen time limit.
Remedies: Contact Technical Service.
!
B4. FAILURE IN RINSING (on machines equipped with the BREAK TANK):
Cause: The Break Tank water was not used during the rinse cycle.
Remedies: Contact Technical Service.
!
B5. BOILER OVERHEATING:
Cause: The water temperature in the boiler exceeded 105°C.
Remedies: Contact Technical Service.
!
B9. BOILER SAFETY THERMOSTAT
Cause: The boiler safety thermostat is tripped.
Remedies: Contact Technical Service.
!
E1. WATER LOAD FAILED:
Cause: The machine wash-tank was not fi lled in the maximum foreseen time
limit.
Remedies: Open the water supply valve and verify a proper water supply fl ow.
!
Contact Technical Service.
E2. TANK PROBE FAILED:
Cause: The circuit board does not detect the wash-tank sensor.
Remedies: Contact Technical Service.
!
E3. TANK HEATING ALARM:
Cause: The factory-set wash-tank temperature was not achieved in the
maximum foreseen time limit.
Remedies: Contact Technical Service.
!
E5. TANK OVERHEATING:
Cause: The wash-tank temperature exceeded 90°C.
Remedies: Contact Technical Service.
!
EN
page 53