12 Welding
Use only welding elements of one batch.
Pay strict attention not to mix welding elements from different batches.
Carry out test welds again after a batch change.
Even the slightest changes to the geometry, in particular to the tip of the
welding elements require different settings for the welding process.
Now check the quality of the welded joint before inserting a new welding
element and repeating the welding process.
Work in accordance with the following point 13.
12.5
Sleep Mode
If the stud welding unit is switched on and no welding is performed, sleep mode
is started after approx. 10 minutes; internal energy consumption is reduced. The
"Ready" LED
End sleep mode by
– actuating the welding gun start button or
– placing the stud welding gun on the workpiece.
42
flashes slowly.
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
©HBS Bolzenschweiss-Systeme GmbH & Co. KG