Bartscher GE 28 Manual page 16

Fig. 2
When the liquid temperature drops, the thermostat switches on again and keeps the
liquid warm at the set temperature for a longer period.
8. If the temperature of 100°C is needed, you may rotate the temperature
controller clockwise until it reaches the right-most 'MAX' position.
EN
WARNING!
When this temperature is reached, the water boils constantly, i.e. the
thermostat does not switch off automatically.
Dispensing Liquids
1. In order to dispense liquid from the pot,
place a suitable container (e.g., a mug,
glass, cup, etc.) under the drain tap.
2. Press the drain tap lever down and hold it
pressed until the right amount of liquid is
dispensed.
3. After the dispensing process, release the
drain tap lever, and it is going to close
automatically.
ATTENTION!
Periodically check the liquid fill level, and refill when required.
Never use the appliance without liquid!
14 / 22
7. Rotate the temperature controller clockwise
to the selected temperature setting.
The red heating-up indicator light is on during
the heating-up phase.
NOTE!
The heating-up time is conditioned by the
liquid and its amount.
When the set temperature is reached, the
thermostat automatically switches off, and the
red heating up indicator light goes off.
Installation and operation
Fig. 3
200049