Table of Contents
Advertisement
Installation and operation
Preparation of Appliance
1. Remove all accessories from the appliance and fully unwind the power cord
from the winder.
2. Rotate the temperature controller to 'OFF' position.
WARNING!
Due to hygienic reasons, the appliance should be boiled up before first
use.
3. Pour approx. 6 litres of water into the pot.
4. Plug the appliance into a single grounded socket.
5. Boil water at the 'MAX' temperature setting for 5 minutes. Observe instructions
in section 'Heating up Liquids'.
6. Next rotate the temperature controller to 'OFF' position.
7. Disconnect the appliance from the socket (pull the plug out).
8. Wait for the appliance to cool off.
9. To end with, drain the water from the pot to a suitable container via the water
drain tap.
10. Rinse with fresh water and drain it again.
11. Clean the appliance observing indications in section 6.2 'Cleaning'.
Heating up Liquids
1. Rotate the temperature controller to 'OFF' position.
2. Before filling the pot with a liquid, make sure the drain tap is closed.
3. Pour the liquid to the mulled wine pot / water pot. Mind the 'MIN' and 'MAX'
markings inside the pot.
WARNING!
Non-drinkable liquids, such as acids, lyes, oils, nitrates, etc. pose hazard
to health.
Before switching the appliance on, always fill the appliance with drinkable liquid.
4. Before switching on, always put the lid on and leave it on the pot during heating
up.
5. Plug the appliance into a suitable single socket.
6. Use the temperature controller to steplessly set the temperature in the range of
30°C – 90°C – MAX.
200049
EN
13 / 22
Advertisement
Table of Contents
