Table of Contents
Advertisement
Installation and operation
Switching the Appliance Off / Emptying the Pot
1. If the appliance is not used, rotate the temperature controller to 'OFF' position.
2. Disconnect the appliance from the socket (pull the plug out).
3. Leave the appliance and the liquid to cool off.
4. Use the drain tap to empty the pot by dispensing the liquid into a suitable
container.
Preserving foodstuffs
The appliance may also be used for preserving suitable foodstuffs in jars. A
maximum of fourteen (14) 1-litre jars with diameter of 11.5 cm may be arranged on
two levels in the pot.
1. Make sure the temperature controller is set in 'OFF' position and the appliance
is disconnected from the electric mains supply.
2. Prepare jars with contents for bottling. Before putting them into the jar, close
them tightly.
3. Put the enclosed grate at the bottom of the pot.
It serves the purpose of an improved circulation of boiling water under and between
jars, thus its faster heating up.
ATTENTION!
Use the enclosed grate only. Galvanized mesh or bar inserts are not
suitable and may cause the appliance to malfunction due to lack of
circulation under such inserts.
4. Place jars on the grate.
5. Pour water into the pot; make sure jars at the top level are covered in water up
to approx. 3/4 of their height.
The water temperature should more less equal the temperature of jars' contents.
This saves time and energy.
NOTE!
When preserving jars arranged on two levels, make sure the bottom level
jars are closed tightly, so that water does not enter them.
6. Place the lid on the pot.
200049
EN
15 / 22
Advertisement
Table of Contents
