Canon FAX L1000 Service Manual page 308

FAX-L1000 Chapter 4: Maintenance and Service
#0021 [RX] DCN received during polling reception
Cause:
Solution: Contact the other party and check subaddress/password of the other party.
#0025 [TX/RX] Automatic dialing setting error
Cause:
Solution: Set confidential and relay correctly for auto dialing.
#0039 [TX] Closed network transmission not possible
Cause:
Solution: Set Service Data #1 SSSW SW07 bit 7 to "1" to switch on closed network
Cause:
Solution: Have the other party switch on the closed network reception switch on
Cause:
Solution: Use Service Data #1 SSSW SW08 to set the same closed network ID for
#0056 [RX] Faulty recording paper feeding
Cause:
Solution: Recover recording paper jam.
#0057 [RX] Faulty recording paper feeding
Cause:
Solution: Recover recording paper jam.
#0058 [RX] Faulty recording paper feeding
Cause:
Solution: Recover recording paper jam.
(21) Check the recording paper eject sensor 2, the cable and the fixing unit
(J131) connections.
(22) Replace the recording paper eject sensor 2.
(23) Replace the ECNT board.
(24) Replace the ECNT board. (Recording paper eject sensor 1 defect)
No subaddress/password set in other machine.
An attempt was made to auto dial with confidential and relay set in auto
dialing.
The closed network transmission switch is switched off.
transmission.
The other fax's closed network transmission switch is switched off.
their fax.
The closed network ID does not match the other fax's.
your fax and for the other fax.
The recording paper jammed when both the pre-feed sensor and the
recording paper eject sensor were OFF.
The recording paper jammed when the pre-feed sensor was ON and the
recording paper eject sensor was OFF.
The recording paper remains fixed when the recording paper eject sensor
is ON.
4-56