No.
Tx or Rx
##0290
[ TX ]
• Printer error codes
No.
Tx or Rx
New ##0322
[ RX ]
New ##0323
[ RX ]
New ##0324
[ RX ]
New ##0325
[ RX ]
• V.8/V.34 protocol error codes
No.
Tx or Rx
New ##0670
[ TX ]
New ##0671
[ RX ]
New ##0672
[ TX ]
New ##0673
[ RX ]
New ##0674
[ TX ]
New ##0675
[ RX ]
FAX-L1000 Chapter 4: Maintenance and Service
Definition
Receive signals other than PIN, PIP, MCF, RTP
or RTN after MPS transmission
Definition
Printer (LBP) fixing unit trouble
Printer (LBP) BD (Beam Detect) trouble
Printer (LBP) scanner trouble
Printer (LBP) main motor trouble
Definition
At V.8 late start, the called party declares the V.8
protocol in DIS signal and this unit transmits a CI
signal, but the protocol does not progress and a T1 time-
out occurs.
At V.8 termination, the protocol did not advance to
phase 2 and a T1 time-out occurs after the caller CM
signal was detected.
The protocol did not move from phase 2 to phase 3 and
a T1 time-out occurred during V.34 transmission.
The protocol did not move from phase 2 to phase 3 and
a T1 time-out occurred during V.34 reception.
The protocol did not move from phase 3 to phase 4 and
a T1 time-out occurred during V.34 transmission.
The protocol did not move from phase 3 to phase 4 and
a T1 time-out occurred during V.34 reception.
4-49