Mercedes-Benz GLC Owner's Manual page 363

Display messages
360
Display messages
Á
Stop vehicle Vehi‐ Stop vehicle Vehi‐
cle too low cle too low
Á
Please reduce Please reduce speed
Á
Compressor is is cool‐ Compressor
ing ing
Possible causes/consequences and M M Solutions
You have pulled away while the vehicle level is still too low.
AIR BODY CONTROL sets the vehicle to the selected level after a
short period.
Pull over and stop the vehicle safely as soon as possible, paying
X
attention to road and traffic conditions.
Secure the vehicle against rolling away (
X
Wait until the display message disappears before pulling away.
X
AIR BODY CONTROL is faulty. A warning tone also sounds.
Do not drive at speeds above 80 km/h.
X
Make only slight steering movements. Otherwise, the front
X
wings or the tyres could be damaged if the steering movement
is too great.
Listen for scraping sounds.
X
Pull over and stop the vehicle safely, paying attention to road
X
and traffic conditions, and set a higher vehicle level.
Depending on the malfunction, it may be possible to raise the
vehicle.
Consult a qualified specialist workshop.
X
You cannot change the vehicle level. Possible causes:
You are driving too fast for the selected vehicle level.
R
speed
You are driving too fast with a trailer or the trailer-coupling
R
socket is being used, e.g. for a bicycle rack.
Drive more slowly and then select the desired vehicle level again
X
( page 252).
Y
Observe the notes on towing a trailer (
X
You have selected a higher vehicle level. The compressor first
needs to cool down because of frequent level changes.
cool‐
Drive in a manner appropriate for the current vehicle level.
X
Make sure that there is sufficient ground clearance.
X
Allow the compressor to cool down.
X
When the compressor has cooled down, the display message
disappears. The vehicle then continues rising to the selected
level.
page 219).
Y
page 303).
Y