Mercedes-Benz GLC Owner's Manual page 266

Activating/deactivating the reversing
camera
To activate: make sure that the key is in
X
position 2 in the ignition lock.
Make sure that the
X
gear gear function is selected in Audio 20 or
COMAND Online (see the Digital Owner's
Manual).
Engage reverse gear.
X
The reversing camera flap opens. The area
behind the vehicle is shown with guide lines
in the Audio 20 or COMAND Online display.
The image from the reversing camera is
available throughout the manoeuvring
process.
To change the function mode for vehi-
X
cles with trailer tow hitch: using the
Audio 20 or COMAND Online controller,
select symbol : for the "Reverse parking"
function or symbol ; for "Coupling up a
trailer".
The symbol of the selected function is high-
lighted.
To deactivate: the reversing camera deacti-
vates if you shift the transmission to P or after
driving forwards a short distance.
Activation by R Activation by R
Messages in the Audio 20 or COMAND
Online display
The reversing camera may show a distorted
view of obstacles or show them incorrectly or
not at all. Obstacles are not shown by the
reversing camera in the following locations:
very close to the rear bumper
R
under the rear bumper
R
in the area immediately above the boot lid
R
handle or tailgate handle
! Objects not at ground level may appear to
be further away than they actually are, e.g.:
the bumper of a parked vehicle
R
the drawbar of a trailer
R
the ball coupling of a trailer tow hitch
R
the rear section of an HGV
R
a slanted post
R
Use the guidelines only for orientation.
Approach objects no further than the bot-
tom-most guideline.
Yellow guide line at a distance of approx-
:
imately 4.0 m from the rear of the vehicle
White guide line without turning the steer-
;
ing wheel, vehicle width including the
exterior mirrors (static)
Yellow guide line for the vehicle width
=
including the exterior mirrors, for current
steering wheel angle (dynamic)
Yellow lane marking the course the tyres
?
will take at the current steering wheel
angle (dynamic)
Driving systems
263
Z