Mercedes-Benz GLC Owner's Manual page 153

Hide thumbs Also See for GLC:
Table of Contents

Advertisement

Windscreen wipers
150
Position trim D and engage it in place by
X
tapping it with your hand.
Before beginning the installation, check
X
that all of the metal clips are inserted in the
parts which were placed on one side: 2
clips ; in the upper section of handle =
and 4 clips A in trim B.
If not, remove the missing metal clips from
X
the panel apertures in the tailgate and
insert them in the corresponding positions.
Grasp trim B and connect plug connector
X
C to the surround lighting.
i
The surround lighting only illuminates
when the tailgate has been shut and reop-
ened.
Vehicles with EASY-PACK tailgate: push in
X
the plug connector for the switch of the
EASY-PACK tailgate in the top right of the
trim.
Vehicles with electric fold-out trailer tow
X
hitch: push in the plug connector for the
electric fold-out trailer tow hitch in the top
left of the trim.
Position trim B and engage it in place by
X
tapping it with your hand, starting from the
outside.
Clip in the lower section of handle : again.
X
Insert and engage the upper section of han-
X
dle = into lower section :.
Windscreen wipers
Switching the windscreen wipers on/
off
! Do not operate the windscreen wipers
when the windscreen is dry, as this could
damage the wiper blades. Moreover, dust
that has collected on the windscreen can
scratch the glass if wiping takes place when
the windscreen is dry.
If it is necessary to switch on the wind-
screen wipers in dry weather conditions,
always operate them using washer fluid.
! If the windscreen wipers leave smears on
the windscreen after the vehicle has been
washed in an automatic car wash, this may
be due to wax or other residue. Clean the
windscreen with washer fluid after an auto-
matic car wash.
! Intermittent wiping with rain sensor: due
to optical influences and the windscreen
becoming dirty in dry weather conditions,
the windscreen wipers may be activated
inadvertently. This could damage the wind-
screen wiper blades or scratch the wind-
screen.
For this reason, you should always switch
off the windscreen wipers in dry weather.
$ Windscreen wipers off
1
Ä Intermittent wipe, low (rain sensor
2
set to low sensitivity)
Å Intermittent wipe, high (rain sensor
3
set to high sensitivity)
° Continuous wipe, slow
4
¯ Continuous wipe, fast
5
í Single wipe
B
î To wipe with washer fluid
Turn the key to position 1 or 2 in the ignition
X
lock (
page 187).
Y
Turn the combination switch to the corre-
X
sponding position.
Vehicles with a rain sensor: in the Ä or
Å position, the appropriate wiping fre-
quency is automatically set according to the
intensity of the rain. In the Å position, the
rain sensor is more sensitive than in the Ä

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents