DLP Projector — Owner's Manual
Remote Control Code
The ten different remote control codes (Code 0 - Code 9) are assigned to this projector. Switching the
remote control codes prevents interference from other remote controls when several projectors or video
equipment next to each other are being operated at the same time. Change the remote control code for
the projector first before changing that for the remote control. See "Projector ID" in the Communications
Menu on page 42.
To change the code for the Remote Control:
Press and hold the Mode button and a number button (0-9) on the remote control for more than three
seconds to switch among the codes.
Default setting : 0
To change the Projector ID for the projector:
Select a Projector Address in this Setting Menu. (SETUP -> Communications -> Projector ID)
10
—
—