Digital Watchdog OMNI-PLUS Snapit DWC-D4382D Manual page 26

REMOTE CONTROL*
To use the remote controller, set the CAMERA ID in the camera's OSD menu. The default setting is 001.
If the CAMERA ID is modified, user must restart the camera; then the camera will be able to recognize
the new ID.
Input the ID number of your camera to the remote controller. After you input the ID number, LED light
will turn on, and your remote controller will be ready to be used.
Press KEY + ID Button to access the camera.
Press ENTER button to access the Menu.
The KEY button will turn the camera into the standby image. The LED will flicker for 20 seconds.
ZOOM IN / ZOOM OUT
These are used to control the lens zoom and to select the
zooming area of the alarm feature.
Select the area you wish to zoom into during motion, and
then select the zoom range, using the
Select TELE button to save the zoom range setting.
If the zoom range during motion is smaller than the zoom
range during standby, alarm zoom range will not be saved.
To turn on the Alarm feature, select
When the button is selected, the camera will zoom from
tele to wide once before the feature turns on. To turn OFF
the Alarm feature, select
26
= Camera ID 001.
Buttons:
WIDE button.
ON/OFF button.
ON/OFF button again.
Menu Access
Zoom Function
and Control
Control
ID Buttons
Motion Alarm
ON & OFF