Menu List - Sony HKCU-IP43F Operation Manual

Menu List

Note
The following conventions are used in the menu list table.
Settings column values (e.g. ON, OFF, 0): Default settings are underlined
Execute using ENTER: Press the CONTROL knob or move the CANCEL/ENTER lever to the ENTER position to execute.
SYSTEM OPERATION menu
SYSTEM OPERATION
Page name Item
Page No.
<CAMERA I/F> OUTPUT
S01
LASER DIODE
START UP VIDEO
SIGNAL
<GENLOCK> REFERENCE
S02
LOCK STATUS
GENLOCK
H-PHASE STEP
H-PHASE COARSE
V-PHASE
SYNC OUT SELECT
Set value
CAMERA, BAR, TEST1, TEST2
ON, OFF
BARS, GRAY
(NOT DETECTED), (1080/59.94I),
(1080/23.98PsF), (720/59.94P),
(1080/50I), (1080/24PsF), (720/
50P), (UNKNOWN)
(LOCKED), (NOT LOCKED)
HD, SD, NETWORK
10F BB OFF, ON
When HD is selected in
GENLOCK:
–3.01 to +3.45 µsec 0.00
When SD is selected in
GENLOCK:
–8.29 to +9.48 µsec 0.00
–99 to 99 0
0 to 7
SD SYNC, HD SYNC
Indication
Selects the output signal.
TEST1 and TEST2 are not selectable if there is no
communication with the camera.
Turns the optical signal output from the CCU to the
camera ON/OFF.
(Displayed only when connected using optical fiber
composite cable.)
Selects the signal to output until the unit connects
with the camera after power-on.
Signal input of the Reference connector (Display
only)
Lock status of the external reference signal (Display
only).
Selects the lock mode of the external reference
signal. (NETWORK is displayed when HKCU-4001 is
installed.)
Sets whether to use the 10Field ID added to the
external reference signal
This can be selected when GENLOCK is SD and
<MULTI FORMAT> page t SYSTEM is 1.001(525).
Adjusts the horizontal lock phase in relation to the
reference signal (steps)
Adjusts the horizontal lock phase in relation to the
reference signal (fine adjustment)
Adjusts the vertical lock phase in relation to the
reference signal (lines)
Sets the output signal of the CHARACTER/SYNC
OUT connector
This is enabled only when MAINTENANCE Menu t
<I/F SETTINGS> page t CHARACTER/SYNC is
SYNC.
35